Selecting A Disinfection Programme - Miele WS 5243 Operating Instructions Manual

Selecting a disinfection programme

Disinfection programmes are locked. The
wash temperature cannot be changed.
Disinfection programmes are locked 1 minute
after a programme has started. They cannot
then be interrupted, stopped or shortened.
The door on the "Clean side" cannot be op-
ened until a programme has finished and dis-
infection has been sucessfully achieved.
Turn the programme selector switch to the
required programme.
The display will then show for example the fol-
lowing:
PROGRAMME 1
95°C Main wash
Rinses
With Pre-wash
To select the "With Pre-wash" programme
block press the Block + T button. The indi-
cator light above the button will light up.
When pressing the Block + T button the fol-
lowing will show in the display:
PROGRAMME 1
>60°C< Pre-wash
95°C Main wash
Rinses
To change the spin speed
The following programme change can be
made before a programme is started:
The spin speed can be changed in 100 rpm
stages from 0 to 300 to a max. of 950 rpm. on
the WS 5243 and to 800 rpm. on the WS
5323.
Press the Start X button
– the programme begins.
M.-Nr. 05730940
TH-Disinfection
1
3 800 RPM
TH-Disinfection
1
1
3 800 RPM
The programme sequence is shown in the dis-
play after the start of the programme.
PROGRAMME 1
60°C Pre-wash
95°C Main wash
nd
The 2 display line shows the actual suds
temperature, in this instance of the Pre-wash,
with the time line extending to the right. The
following programme block, in this instance
the Main wash, is shown underneath it.
PROGRAMME 1
95°C Main wash
Rinse 1
When the Pre-wash programme block has fin-
ished, the Main wash programme block ap-
nd
pears in the 2 line of the display, with the
actual suds temperature, and the time line ex-
tending off to the right. The next programme
block, here Rinse 1, is shown underneath it.
If an arrow appears in the last line at the right
hand side ( à ), this indicates that there is an-
other display line to follow.
Pressing the cursor 2 button brings up
further information relating to the PRO-
GRAMME in the lower lines.
Programme end display
After water from the last heating phase has
drained away or after the last "Cool Down"
the programme end time is shown in hours
and minutes.
PROGRAMME 1
Rinse 1
Rinse 2
Programme end
16
TH-Disinfection
20°C
TH-Disinfection
20°C
TH-Disinfection
11 : 25 hrs
à
à
à