I.m.s (Intergrated Memory System) - Hyundai XG300 2001 Owner's Manual

B090D01Y-AAT
Adjusting Seatback Angle
Rotate the upper portion of the control knob
forward or backward to recline the seatback to
the desired position. Release the control knob
and the seatback will remain in that position.
WARNING:
To minimize the risk of personal injury in
the event of a collision or a sudden stop,
both the driver's and passenger's seatback
should remain in an upright position while
the car is in motion. The protection provided
by the seat belts and airbags may be re-
duced significantly when the seatbacks are
reclined. There is a greater risk that the seat
occupants will slide under the belt resulting
in serious injury if a crash occurs when the
seatbacks are reclined. The seat belt cannot
provide full protection to an occupant if the
seat back is reclined.
1- 10
FEATURES OF YOUR HYUNDAI
B090E02L-AAT

I.M.S (Intergrated Memory System)

(If installed)
B090D01Y
The I.M.S is on the driver's door. After adjusting
the position of the driver's seat and the outside
rearview mirrors, use the I.M.S to memorize
them. Two different driving position profiles can
be entered in the I.M.S. If you turn the ignition
key to the "ON" position, the memorized posi-
tion is adjusted automatically.
To memorize the driving position
1. Turn the ignition key "ON".
2. Adjust the driver's seat, and outside rear-
view mirrors to the desired position.
3. Push the "M" button on the I.M.S until the
signal beeps.
4. Within five seconds, push button "1" or "2"
until the signal beeps twice. The beep sounds
mean that the positions are memorized in
the I.M.S.
CAUTION:
In the following conditions, the I.M.S. will
not operate:
1. When the "1" or "2" button is not pushed
whithin five seconds.
2. When the seat is being adjusted.
3. When the "STOP" button is pushed.
To activate the memorized position
When you push button "1" or "2", the driving
position will be automatically adjusted to the
position recorded for that button.
To activate the "AUTO" button
When the "AUTO" button is "ON", the driver's
B090E01L
seat moves forward or rearward automatically
so you can get in or out comfortably.
o The driver's seat moves rearward when the
ignition key is pulled out.
o The driver's seat moves forward when the
ignition key is inserted.
o While the vehicle is moving backward, the
outside rearview mirrors will automatically
move downward to change the area visible
with the outside mirrors.
NOTE:
If the remote control outside rearview mirror
switch knob is located in the middle posi-
tion of the switch, the outside rearview mir-
rors will not operate while the vehicle is
moving backward. When the shift lever is
moved to the "R" position, only the