Power Steering Fluid Level; Power Steering Hoses; For More Information About Your Hyundai; Replacing Light Bulbs - Hyundai XG300 2001 Owner's Manual

will automatically shut off. This is a normal
condition.
G220B01A-AAT
Checking Engine Cooling Fan
The engine cooling fan should come on auto-
matically if the engine coolant temperature is
high.
G220C01A-AAT
Checking Condenser Cooling Fan
The condenser coolant fan should come on
automatically whenever the air conditioning is
in operation.
G230A01L-AAT

POWER STEERING FLUID LEVEL

The power steering fluid level should be checked
regularly.
To check the power steering fluid level, be sure
the ignition is "OFF", then check to make cer-
DO-IT-YOURSELF MAINTENANCE
tain that the power steering fluid level is be-
tween the "MAX" and "MIN" level markings on
the fluid reservoir.
NOTE:
Grinding noise from the power steering
pump may be heard immediately after the
engine is started in extremely cold condi-
tions (below -4°F). In this case, if the noise
stops during warm up, there is no abnormal
function in the system. This is due to a
power steering fluid characteristic in ex-
tremely cold conditions.
Recommended Fluid
Use PSF-3 fluid.
NOTE:
Do not start the engine when the power
steering oil reservoir is empty.
G240A01A-AAT

POWER STEERING HOSES

It is suggested that you check the power steer-
ing hose connections for fluid leakage at regular
intervals. The power steering hoses should be
replaced if there is severe surface cracking,
scuffing or worn spots. Deterioration of the
hose could cause premature failure.
G090A01Y
G250A01A-AAT
FOR MORE INFORMATION ABOUT
YOUR HYUNDAI
If you desire additional information about main-
taining and servicing your Hyundai, you may
purchase a factory Shop Manual at your Hyundai
dealer's parts department. This is the same
manual used by dealership technicians and
while it is highly technical it can be useful in
obtaining a better understanding of your car
and how it works.
G260A01A-AAT

REPLACING LIGHT BULBS

Before attempting to replace a light bulb, be
sure the switch is turned to the "OFF" position.
The drawings show how to reach light bulbs so
they may be changed. Be sure to replace the
burned-out bulb with one of the same number
and wattage rating.
6-13