Table of Contents
Advertisement
NOTE:
Once the system has been disarmed, it can
not be rearmed except by repeating the
arming procedures.
CAUTION:
Only the transmitter can disarm the armed
stage. If the transmitter is out of order at the
armed stage, it is necessary to take the
following steps;
1. Open the door by the key. In case of this,
the alarm will be activated.
2. Insert the key in the ignition key cylinder
and turn the ignition key to "ON" posi-
tion.
3. Wait for 30 seconds.
After completion of the steps above, the
system will be disarmed.
Keyless Entry System
Locking doors
1. Close all doors.
2. Push the "LOCK" button on the transmitter.
3. All doors will lock and the turn signal lamp
will blink twice to indicate that the system is
armed.
1- 6
FEATURES OF YOUR HYUNDAI
Unlocking doors
1. Push the "UNLOCK" button on the transmit-
ter.
2. All doors will unlock and the turn signal lamp
will blink once to indicate that the system is
disarmed.
Operating the window (driver's only)
To open the window, push the unlock button on
the transmitter for longer than 1 second after all
the doors are unlocked.
NOTE:
The transmitter cannot close the driver's
and passenger's windows.
Releasing the trunk lid
Push the trunk lid release button on the trans-
mitter.
B060A01L-AAT
POWER WINDOWS
Close
Open
(2)
The power windows operate when the ignition
key is in the "ON" position. The main switches
are located on the driver's armrest and control
the front and rear windows on both sides of the
vehicle. The windows may be opened by de-
pressing the appropriate window switch and
closed by pulling up the switch. To open the
window on the driver's side, press the switch(1)
halfway down. The window moves as long as
the switch is operated. To fully open the driver's
window automatically, press the switch fully
down. In automatic operation, the window will
fully open even if you let go of the switch. To
stop at the desired opening, pull up and release
the switch. In order to prevent operation of the
passenger front and rear windows, a window
lock switch(2) is provided on the armrest of the
driver's door. To disable the power windows,
press the window lock switch. To revert to
normal operation, press the window lock switch
a second time. The power windows can be
operated for 30 seconds after the ignition key is
turned to the "ACC" or the "LOCK" position.
However while the front doors are opened, the
(1)
power windows cannot be operated.
B060A01L
Hide quick links:
Advertisement
Table of Contents
