Recording Audio.16; Recording Video.16 - Kenwood VR Series Instruction Manual

VR/KRF-V SERIES (ErVKMl
l Muting the sound
MUTE lets you mute the sound of the speakers.
Press the MUTE key.
Blinks
• On the VR-306, VR-305, VR-355 and KRF-V5020,.this selection can
be made using the control on the receiver as well.
To cancel _ ^ m „
Press the MUTE key again so that the "MUTE Indicator goes off.
♦ Muting can also be cancelled by adjusting the volume.
SOURCE DIRECT playback (analog sources only)
Use this function to pass the source material direct to the amplifier,
bypassing any audio processing.
Press the SOURCE DIRECT key.
• Either press the LISTEN MODE. SOUND, and SETUP keys, or
switch to another input source to cancel SOURCE DIRECT play¬
back.
To cancel
Press again.
• If SOURCE DIRECT playback was activated when using a sur¬
round mode, cancelling it reactivates the previous surround mode.
Listening with headphones
O Press the SPEAKERS A or B key (or the SPEAKERS key) so that
• If you turn off all of the speakers when in the surround mode, the
mode is cancelled as well, resulting in stereo playback.
G
Connect headphones to the PHONES jack.
G
Use
the
VOLUME CONTROL (VOLUME)
to adjuet the volume.
To adjust the balance
Recording audio
VIDEO 2/MONITOR
Recording a music source
When recording a music source, switch the VIDE02/M0NIT0R
setting to "MONITOR".
O Use the Input selector to select the source (other than "TAPE")
you want to record.
G Set the cassette deck to record.
G
Start playback, then start recording.
Copying tapes
When copying tepee, switch the VIDE02/MONJTOR setting to
"MONITOR".
MONITOR -» TAPE copying |
O Press the VIDE02/M0NIT0R
key.
G
Use the Input selector to select a source other than "TAPE".
G
Start playback on the cassette deck connected to the VIDE02/
MONITOR jacks and start recording on the cassette deck con¬
nected to the MD/TAPE jacks.
I TAPE -» MONITOR copying
O Use the Input selector to select "TAPE".
G
Start playback on the cassette deck connected to the MD/TAPE
jacks and start recording on the cassette deck connected to the
V1DE02/M0NIT0R jocks.
• To copy tapes using a double cassette deck, refer to the instruc¬
tion manual of the double cassette deck.
MONITOR function
You can connect a cassette deck or graphic equalizer to the VIDE02/
MONITOR jacks of the receiver. If a graphic equalizer is connected, the
VIDE02/M0NIT0R key should be left in the on position. Alternately, if a
cassette deck equipped with a 3-head system is connected to the
VIDE02/M0NIT0R jacks, you will be able to monitor the just-recorded
signal while making recordings on the cassette deck. By switching the
VIDE02/MONITOR key on and off, you can compare the sound of the
source signal and the just-recorded signal. For more information, referto
the instruction manual of the connected component.
To adjust the input level when the monitor function is turned on,use^
SOUND key and the MULTI CONTROL key.
Recording video
_
Whan recording video, switch the VIDE02/MONITOR eetdngto
"VIDE02".
^
O Use
the Input selector to select the video source (other then
"VIDE02") you went to record.
G
Set the video deck connected to V1DE02/MONITOR to record.
Ih start nlAvbark. then start reeordlna.