Table of Contents
Advertisement
Assembling
Attaching the Music Rest
The HPi-50's music rest has a built-in liquid crystal display.
Attach the music rest as described in the following procedure, and
handle it with care.
Seen from behind
Screw
1.
Remove the music rest screws (two locations) from the
top surface .
2.
Fasten the music rest using the screws you removed .
Use one hand to support the music rest, use the other hand to
tighten the screws. When attaching the music rest, use your hand to
support it so that it does not fall. Take care not to pinch your hand.
NOTE
• Do not apply excessive force to the music rest.
• You must use the included screws to attach the music rest.
• For safety, be sure to remove the music rest before transporting
the HPi-50e.
• Take care that the music rest attachment screws you remove are
not lost or accidentally swallowed by small children.
• Completely remove the screws from the top surface before
attaching the music rest. If screws are left on the top surface
when you attach the music rest, the top surface may be
scratched.
• The screwdriver needed to perform the assembly is not
supplied. You'll need to have ready a Phillips screwdriver that
matches the size of the screws.
3.
Fit the latch into one of the slots so that the music rest is
at the desired angle .
74
Connecting the Display Cable
Screw
2
Coated clip
1.
Connect the music rest display cable to the display cable
connector located on the bottom of the HPi-50e .
NOTE
You must turn off the power before connecting the display
cable.
2.
Use the coated clip on the bottom of the piano to fasten
the display cable .
1
Advertisement
Table of Contents
