Turning The Power On/Off - Roland HPi-50e Owner's Manual

Turning the Power On/Off

NOTE
• Once everything is properly connected, be sure to follow the procedure below to turn on their power. If you turn on equipment in the wrong
order, you risk causing malfunction or equipment failure.
• Before turning the unit on/off, always be sure to turn the volume down. Even with the volume turned down, you might hear some sound when
switching the unit on/off. However, this is normal and does not indicate a malfunction.
1
Min
3
Min Max
Turning the power on
1.
Move the [Volume] slider all the way to the left to minimize the volume .
2.
Press the [Power] switch .
The power will turn on, the music rest screen will show an opening animation, and then the notation screen (p. 14) will appear.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after turning the unit on is required before it will operate normally.
3.
Use the [Volume] slider to adjust the volume .
This will adjust the volume of the speakers if you're using the speakers of the unit, or the volume of the headphones if headphones are connected.
Each volume setting (for speaker or headphone) is saved automatically.
Turning the power off
1.
Move the [Volume] slider all the way to the left to minimize the volume .
2.
Press the [Power] switch .
The screen goes blank and the power is turned off.
If you don't want the power to turn off automatically, change the "Auto Off" setting to "Off"!
With the factory settings, the HPi-50e's power will automatically be switched off 30 minutes after you stop playing or operating the
unit.
If the unit's power has been turned off automatically, you can use the [Power] switch to turn the unit back on again. If you don't want the power
to turn off automatically, change the "Auto Off" setting to "Off" as described on "Making the Power Automatically Turn Off After a Time ( Auto
Off )" (p. 52).
NOTE
• When turning the power on again, you must allow at least five seconds after power-off before you once again turn the power on. If you fail
to allow enough time, the Auto Off function might not be reset, preventing the power from turning on correctly.
• The settings will be initialized after the power has been turned off. If you want to still be retained the next time you turn on the power, you
should refer to "Having Your Settings Be Retained after the Power Is Turned Off (Memory Backup)" (p. 12) and save your settings.
2
On
Power
Off
Before You Play
19