Connecting Wires To Terminals - Kenwood CarPortal KOS-V1000 Instruction Manual

Connecting Wires to Terminals

Connector Function Guide
Pin Numbers for Cable Colour
ISO Connectors
External Power
Connector
A-4 Yellow
A-5 Blue/White
A-6 Orange/White
A-7 Red
A-8 Black
Speaker
Connector
B-1 Purple
B-2 Purple/Black
B-3 Gray
B-4 Gray/Black
B-5 White
B-6 White/Black
B-7 Green
B-8 Green/Black
2WARNING
Connecting the ISO Connector
The pin arrangement for the ISO connectors depends on
the type of vehicle you drive. Make sure to make the proper
connections to prevent damage to the unit.
The default connection for the wiring harness is described
in 1 below. If the ISO connector pins are set as described in
2 or 3, make the connection as illustrated.
Please be sure to reconnect the cable as shown 2 below to
install this unit to the Volkswagen vehicles etc.
1 (Default setting) The A-7 pin (red) of the vehicle's
ISO connector is linked with the ignition, and
the A-4 pin (yellow) is connected to the constant
power supply.
Ignition cable (Red)
Unit
Battery cable (Yellow)
2 The A-7 pin (red) of the vehicle's ISO connector is
connected to the constant power supply, and the
A-4 pin (yellow) is linked to the ignition.
Ignition cable (Red)
Unit
Battery cable
(Yellow)
84 KOS-V1000
Functions
Battery
Power Control
Dimmer
Ignition (ACC)
Earth (Ground)
Connection
Rear Right (+)
Rear Right (–)
Front Right (+)
Front Right (–)
Front Left (+)
Front Left (–)
Rear Left (+)
Rear Left (–)
A-7 Pin (Red)
Vehicle
A-4 Pin (Yellow)
A-7 Pin (Red)
Vehicle
A-4 Pin (Yellow)
3 The A-4 pin (yellow) of the vehicle's ISO
connector is not connected to anything, while
the A-7 pin (red) is connected to the constant
power supply (or both the A-7 (red) and A-4
(yellow) pins are connected to the constant
power supply).
Ignition cable (Red)
Unit
Battery cable (Yellow)
⁄
• When the connection is made as in 3 above, the unit's
power will not be linked to the ignition key. For that
reason, always make sure to turn off the unit's power
when the ignition is turned off.
To link the unit's power to the ignition, connect the
ignition cable (ACC...red) to a power source that can be
turned on and off with the ignition key.
A-7 Pin (Red)
Vehicle
A-4 Pin (Yellow)