Help? Troubleshooting - Kenwood CarPortal KOS-V1000 Instruction Manual

Kenwood advanced integration controller instruction manual
Hide thumbs Also See for CarPortal KOS-V1000:
Table of Contents

Advertisement

Help?
Troubleshooting
Some functions of this unit may be disabled by
some settings made on this unit.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
Subwoofer is not set to On.
(page 56)
The Dual zone function is enabled.
Control> (page 76)
!
Cannot set up the subwoofer phase.
Subwoofer is not set to On.
(page 56)
Low pass filter is set to Through.
Network Setup> (page 57)
!
• Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
The Dual zone function is disabled.
Control> (page 76)
!
Cannot Folder select.
The Scan play or Random play function is
enabled.
!
• Cannot set up the equalizer.
• Cannot set up the crossover network.
The Dual zone function is enabled.
Control> (page 76)
78
KOS-V1000
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
<Audio Setup>
<Zone
Tuner source
<Audio Setup>
<Crossover
Audio file source
<Zone
<Zone
?
The Touch Sensor Tone doesn't sound.
The preout jack is being used.
The Touch Sensor Tone can't be output from
the preout jack.
?
Radio reception is poor.
The car antenna is not extended.
Pull the antenna out all the way.
The antenna control wire is not connected.
Connect the wire correctly, referring to the
section on <Connection> (page 82).
?
The sound skips when an Audio file is being
played.
The recording condition is bad.
Record the media again or use another
media.

Advertisement

Table of Contents
loading

Table of Contents