Installation - Kenwood CarPortal KOS-V1000 Instruction Manual

Installation

Installation for Remote control sensor
Wipe off the installation location with a
1
cleaning cloth.
2 Secure the Remote control sensor (Accessory
8) in the specified place with the double-
sided adhesive tape.
• Install the Remote control sensor on a flat surface. If it
is installed on a curved surface, the tape adhesion may
weaken and the controller may come off.
• Do not install the Remote control sensor in places (such
as on the dashboard) where it is exposed to direct
sunlight and the temperature becomes high. Otherwise,
the Remote control sensor will become deformed and
unusable.
• Install the Remote control sensor in places that do
not obstruct driving. Install the Remote control sensor
temporarily and verify that the handle, shift knob, and
side brake can be operated smoothly.
88 KOS-V1000
Installation for A/V controller Unit
1
Double-sided
adhesive tape
2
3
Remove the cover using the Hexagon Wrench
(Accessory#).
Hexagon Wrench
(Accessory#)
Use Tapping screws (Accessory7) to fix A/V
controller Unit onto an audio board or another.
Tapping screw (ø4 × 16 mm)
Put the cover back on.
(Accessory 7)