How To Format The Hdd After Replacement - FUNAI BH2-M200 Service Manual

HOW TO FORMAT THE HDD AFTER REPLACEMENT

Note: HDD format is needed after replacing the HDD.
Enter the Self Check Mode and complete HDD
format by following the procedure below.
1. Turn the power on.
2. Put the unit into HDD/DISC mode. Remove the
disc on the tray and close the tray.
3. Press [i] (skip up), [0], [7], [9] buttons on the
remote control in this order. The unit enters Self
Check Mode and the following screen will be
displayed.
Self Check
Loader Connect Status
HDD Connect Status
HDD Power On Hours
Power Off : POWER
F/W Name : *******
Release Ver. : ****
Fig. a Self Check Mode Screen
4. Connection check for loader and HDD starts
automatically. After the self check is completed,
the following screen appears.
Self Check
Loader Connect Status
HDD Connect Status
HDD Power On Hours
This system is unconstruction of the file system.
HDD Format : OK
Power Off : POWER
F/W Name : *******
Release Ver. : ****
Fig. b Screen Display After the Self Check
5. Press [OK] button on the remote control. The
power will turn off. On the LCD, "WAIT" message
is displayed and HDD format begins.
Fig. c LCD during HDD format
Note: Because HDD format is performed in standby
mode, the screen will be black.
" * " differ depending on the models.
: --
: --
: --
Region : *-*
" * " differ depending on the models.
: SUCCESS
: SUCCESS
: ***
Region : *-*
6. When format is completed, clock display appears
on the LCD.
Note:
• Make sure the "WAIT" message on LCD has
disappeared before unplugging the AC cord.
• It may take up to 10 or more seconds to complete the
HDD format.
1-10-1 E4V20HDR