BD/HDD MAIN CBA UNIT REPLACEMENT
When replacing the BD/HDD Main CBA Unit, the
board and HDD needs to be matched to one another.
Follow the procedure below to complete the matching
process.
1. Turn the power on.
2. Put the unit into HDD/DISC mode. Remove the
disc on the tray and close the tray.
3. Press [i] (skip up), [3], [1], [0] buttons on the
remote control in this order. The following screen
will be diplayed.
" * " differ depending on the models.
Main PCB Change Mode
Status
: Incorrect
Please input [7]+[8]+[9] key.
F/W Name : *******
Release Ver. : ****
Fig. a Main PCB Change Mode Screen
Description of *1
Indication
Need to complete the matching
Incorrect
process.
Matching process is not
OK
necessary.
NG
HDD problem (not connected).
4. To perform the matching process, press [7], [8], [9]
buttons on the remote control in this order within 3
seconds.
5. After the process completes, the result is
displayed next to the "Status :" on the screen.
("SUCCESS" at success or "ERR24" at error.)
Main PCB Change Mode
Status
: SUCCESS
[POWER] : Power Off
F/W Name : *******
Release Ver. : ****
Fig. b "SUCCESS" Screen
Region : *-*
State
" * " differ depending on the models.
Region : *-*
6. Press [STANDBY/ON] button to turn the power off.
7. Unplug the AC cord.
*
1
1-9-1
E4V20BDR