Additional Extension Settings - BT Versatility Get Started

Additional Extension Settings

See the table below for a full range of settings. The following parameters may
be also be set on an extension by extension basis. Refer to the full 'User
Manual' for detailed programming instructions if required.
25 Hz
This allows the ringing frequency to be changed from 25 to 50 Hz.
The default setting is 25Hz however some older phone equipment
may require 50 Hz for ringing this setting should only be applied if a
telephone does not ring correctly at 25 Hzv
3.1 kHz Extension
Allows an outgoing call to be set for 3.1Khz minimum bandwidth. It is
advisable to set this for extensions equipped with a Fax or Modem
Extension Disconnect
Removes an unpopulated extension from all ring maps
Hot Line
Allows an extension to be set to call a pre-programmed number when
the extension goes off hook. Typically used for unsupervised
reception areas or fax machines
Individual CLI Stores
The administrator can decide which extensions have individual CLI
stores
Key Pad Feedback
Allows the keypad tones to be switched on/off on an extension by
extension basis.
Manager/Secretary
Allows specific features to be mapped between a manager and
secretary for improved functionality
No Call Logging
Prevents calls to or from this extension from being stored in the
system call logging information
External Diversions
This prevents or allows extensions from setting up diverts externally
and also prevents an extension from making dual trunk calls, such as
External Transfer, Conference or Consultation
Open Door Restriction
An extension can be restricted from Opening the Door if a remote
door opening system is installed
BT Versatility
Get started user guide
25