Reebok PowerBike REM-11200 User Manual page 17

Reebok Fitness RB Bike Series – PowerBike
4: Saddle and Saddle Stem Assembly:
Place the Saddle (60) on the floor and remove the pre-assembled nuts and washers, place
the Saddle Post (63) over the captive bolts on the underside of the Saddle and replace the
washers and nuts. Tighten with Spanner (102). Slide the Saddle post sleeve (64) over the
Saddle post (63), if not already pre-assembled.
Insert the assembled Saddle (60), Saddle Stem (63) and Saddle Post sleeve (64) into the
Base Frame (31). When done insert the Saddle Height Adjustment Knob (65) into the Base
Frame (31) and select the correct height you wish the saddle to be, then fully tighten the
Adjustment Knob (65).
Please note in order to adjust the height of the saddle you do not have to fully remove the
Adjustment Knob, undo the knob a couple of turns and then pull, the knob is sprung loaded.
www.reebokfitness.co.uk
17
Issue 1 – August 2004