Install the RPS cage.
9.
Insert the RPS backplane module cables into the media drive cage, and then slide the module into the
10.
lower media drive bay. Align the left edge of the module with the guide mark on the bay.
Connect the eight-pin to four-pin adapter cable to the eight-pin power supply connector of the RPS
11.
backplane module.
Connect the RPS cables to the system board. For detailed cabling information, see "Redundant power
12.
supply cabling."
The RPS cable assembly contains one extra cable which is not utilized in this server. Ensure that the extra
cable is out of the way of the connected RPS backplane module cables.
Hardware options installation 53