Connect each power cord to the power source.
12.
Power up the server (on page 16).
13.
Eight-bay SFF hot-plug drive cage option
To install the component:
Power down the server (on page 16).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the tower bezel (on page 17).
3.
Remove the access panel (on page 18).
4.
Remove the air baffle (on page 19).
5.
Remove all installed drives.
6.
Disconnect the drive cage cables:
7.
Disconnect the Mini-SAS cable from the system board.
a.
Disconnect the drive power cable from the 10-pin power supply connector.
b.
Remove the LFF drive cage assembly.
8.
Hardware options installation 34