Expansion Board Options - HP ProLiant ML310e User Manual

Install the DIMM.
7.
Install the air baffle (on page 20).
8.
Install the access panel (on page 19).
9.
Lock the tower bezel.
10.
Connect each power cord to the server.
11.
Connect each power cord to the power source.
12.
Power up the server (on page 16).
13.
After installing the DIMMs, to configure memory protection mode, use RBSU
on page 71).

Expansion board options

The server has both full-height and low-profile expansion slots.
CAUTION:
all PCI slots have either an expansion slot cover or an expansion board installed.
To install the component:
Power down the server (on page 16).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Unlock the tower bezel (on page 17).
3.
Remove the access panel (on page 18).
4.
Remove the air baffle (on page 19).
5.
To prevent improper cooling and thermal damage, do not operate the server unless
("HP ROM-Based Setup
Hardware options installation 45
Utility"