Wireless Ip Camera Access - HIKVISION 2DC Series User Manual

3.6Wireless IP Camera Access

[Notice] The following message only introduces the –W series wireless IP camera. Take the IE
Browser Access for example.
Before configure parameters of the wireless IP camera, you should set the wireless router. The
following example is TP-LINK. Firstly configure the "network parameter" of the "LAN setting" and
"WAN setting" in the wireless router's management page. Enter the "Wireless Parameter", and set the
"SSID NO.", "Frequency band" and "Mode". User can input any letter and number in the "SSID NO." ;
"Frequency Band" is selected according to the on-the-spot environment, and usually we recommend 6
frequency band; Select the "54Mbps(802.11g)". Select the "Enable Wireless Function" and "Allow SSID
Broadcast".
User can select "Enable Security Function" according to the on-the-spot environment. You can
select the "Security Type", "Security Option", "Key Mode Option" and "Key Content". Please refer to the
introduction of the wireless router to get the detailed configuration. As shown:
Fig.3-5-2 DNS Server
Fig.3-6-1 Router wireless parameter configuration
24