Install The Aircard Usb Modem; Insert The Battery; Insert The Sim Card - Sierra Wireless AirCard 800 Series Installation Manual

AirCard 800 Series USB Modem Installation Guide
Note: To prevent the SIM from
becoming jammed in the AirCard
USB modem slot, ensure the
edge of the SIM is smooth
before inserting it. Do not attach
labels to your SIM as this may
also cause it to become jammed.
16

Install the AirCard USB modem

The main steps are:
1. Insert the battery into the modem.
2.

Insert the SIM card.

3. Install the Watcher software.
4. When instructed to do so, insert the AirCard USB modem
into the USB slot.
5. Configure the AirCard USB modem to use your account
(unless it was pre-configured).
6. If your Internet browser is configured to use a dial-up
modem, you may need to set the browser to use a network
card.

Insert the battery

Caution: A risk of explosive exists if the battery is replaced by an
incorrect type. Dispose of batteries according to the instructions on
the battery.
To insert the battery into the AirCard USB modem:
1. Slide the front panel off the AirCard USB modem.
2. Hold the battery so that the side with two white arrows
faces up and the gold contact points on the end of the
battery line up with the gold contact points on the modem.
Insert the battery into the AirCard USB modem.
3. If you also need to install a SIM card, proceed to the next
section, "Insert the SIM
panel onto the AirCard USB modem, and push it gently
until the panel clicks in place.
For additional battery information, see
Insert the SIM card
To install your SIM card into the AirCard USB modem:
1. If your SIM card is attached to a larger card, detach the
SIM card and remove any fragments stuck to it.
2. If you haven't already done so, slide the front panel off the
AirCard USB modem.
3. Slide the SIM card slot cover to the OPEN position and lift
the cover.
card". Otherwise, slide the front
page 33.
2130784