HE40T with BH1/BH2 Battery Handle — Firmly push the
8-pin connector into the back end of the reader, as shown in
Figure 1–15. The cable has a locking mechanism that will
firmly hold the cable in place. To detach the cable from the
reader, you must pinch the plastic on the 8-pin DIN and pull
back to disengage the connector.
USB Cable Connection
Attach the USB cable to the HE40T.
Connect the USB cable to the host in any available USB host
port, as shown in Figure 1–16. You DO NOT need to power off
your host computer.
Once properly connected to the host computer, the HE40T will
power on and beep. The reader is shipped pre-configured.
Rev 1.0.1, Dec. 2006
Handle with Cable Attached
Connecting the USB Cable
HE40T Quickstart Guide