Belling FSE 54 DO Service Manual page 37

INSTALLATION INSTRUCTIONS - ELECTRIC
WARNING: IN ORDER TO PREVENT TIPPING OF THE
APPLIANCE, EITHER THIS STABILISING MEANS OR THE
STABILISING BRACKET SUPPLIED MUST BE INSTALLED.
Anti -Tilt Device
This cooker is supplied with anti-tiling chains and anti-tiling bracket to prevent
accidental tilting of the cooker. To fit the bracket, please refer to the instruction manual
supplied with your cooker. To fit the chains, please install as follows:
• Remove the two screws located on the rear panel, approximately 500mm above
the floor.
• Fix each chain to the cooker with the screws.
• Fix each chain to the floor or the wall with suitable fasteners which suit the floor/
wall material and easily retains the weight of the cooker.
•
Warning: in order to prevent accidental tipping of the appliance, for example
by a child climbing onto the open oven door, the stabilising means must be
installed. The chains and bracket are a safety device and either must be fit-
ted to all cookers. Failure to fit the chains or a bracket properly may cause
personal burn injuries and damage to the appliance.
If the chains cannot be fitted because the appliance is between cupboards, please drill
a hole on each side of the cupboards, pass the chains through the holes and anchor
the chains within each cupboard.
Important: After fixing the chains ensure the chains are taut and the cooker
does not tilt forward or side ways.