Init Display First; Ide Hdd Block Mode - Aaeon PCM-6892 User Manual

All-in-one single board computer onboard via c3 ebga cpu with lcd, lvds, tv-out, audio, dual ethernet, cfd, pcmcia, & 4 usb

Hide thumbs Also See for PCM-6892:

Table of Contents

Primary/Secondary Master/Slave PIO

The four IDE PIO (Programmable Input/Output) fields let you set a

PIO mode (0-1) for each of the two IDE devices and the two storage

devices that the onboard IDE interface supports. Modes 0 through

4 provide successively increased performance. In Auto mode, the

system automatically determines the best mode for each device.

The choices: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode 4

Secondary Master/Slave PIO reserves for future purpose

Primary/Secondary Master/Slave UDMA

Ultra DMA33/66/100 implementation is possible only if your IDE

hard drive supports it and the operating environment includes a

DMA driver. If your hard drive and IDE cable both support Ultra

DMA 33/66/100 select Auto to enable BIOS support.

The choices: Auto, Disable.

Secondary Master/Slave UDMA reserves for future purpose

Init Display First

You can select AGP or PCI slot to initialize it as the primary display

before initializing any other display device on the system.

The choices:AGP, PCI Slot

Block mode is also called "block transfer", "multiple commands", or

"multiple sector read/write". If your IDE hard drive supports block

mode (most new drives do), please select "Enabled" for automatic

detection of the optimal number of block read/writes per sector the

drive can support.

The choices: Enabled, Disabled.

Chapter 3 Award BIOS Setup

Table of Contents