Vaddio wallview hd-20 dvi/hdmi high definition robotic ptz camera featuring the quick-connect™ dvi/hdmi sr interface and the conceal™ wall mounting system (20 pages)
Page 2
Read and understand all instructions before using. Do not operate any device if it has been dropped or damaged. In this case, a Vaddio technician must examine the product before operating. To reduce the risk of electric shock, do not immerse in water or other liquids and avoid extremely humid conditions.
Page 3
Three (3) 10-32 x .5” Pan Head Screws attach through the camera platform to the 2.5” stand-offs* Vaddio HD-20 or HD-18 PTZ Camera Not Assembled 12” Smoke tinted dome with three (3) stainless steel screws and metal retention ring attached These parts are pre-assembled.
Page 4
Camera is not included. Other things that are needed for system completion: One (1) Vaddio HD-20, HD-19 or HD-18 PTZ Camera Package 18AWG, 2-Conductor Cable (for power supply extension to Heater Blower - up to 100’ /30.48m) ...
Page 5
Vaddio HD-20, HD-19 and HD-18 PTZ cameras use Cat-5e cable for video, power and control. When terminating the Cat-5e cabling, please make sure that each cable is marked and tested for proper termination of all ends with a continuity tester. Please do not use the “pass -thru” type RJ-45 connectors.
Page 6
DomeVIEW HD Weather-Resistant 12” Outdoor Pendant Mount Dome Camera Platform and Heater/Blower Components: When powered up, the fan will run continuously. The heater resistor will turn on at 45° F (7.22222 ºC) to keep the contents warm. Operating range with the heater blower is -10°F to 115°F (-23.3ºC to 46.1ºC). Step 5: Connect the 18/2 cable to the green Phoenix type connector as shown (circuit board is marked +24VDC and GND).
Page 7
Vaddio Customer Service: Vaddio will test, repair, or replace the product or products without charge if the unit is under warranty and is found to be defective. If the product is out of warranty, Vaddio will test then repair the product or products. The cost of parts and labor charge will be estimated by a technician and confirmed by the customer prior to repair.