How to use SSB antenna for DSC routine frequency receive
To use the SSB radiotelephone antenna for routine watch keeping, the following
modification is necessary.
On the TX_FIL Board (05P0736)
1. Attach the jumper wire to JP1 on the TX-FIL board.
2. Disconnect the coaxial cable from J3, and reconnect it to J9.
3. Connect the coaxial cable, coming from J2 on the W/R2 board, to J10 on the TX-FIL
board.
On the W/R2 Board (05P0734)
1. Disconnect the coaxial cable from J4 on the W/R2 board, and then tie it with the cable
tie (local supply) with the other cable.
2. Connect the coaxial cable from the TX_FILL Board to J4.
4-2
TX_FIL Board, 05P0736
TX_FIL Board
05P0736
J2
I/F
circuit
J9
J10
K15
JP1 JP2
J3
JP2
JP1
I/F
circuit
TX_FIL Board
J3
to TX-RX Board
J9
to PRE SEL Board
(05P7461 J1)
to J2 on W/R Board
J10