Cold-Starting - Wacker Neuson BTS Series Operator's Manual

7.7

Cold-starting

T00962GB
ATTENCION:
By all means make sure that outer edge of stop plate (4) is parallel to
the edge of the protective hood (see arrows).
Visit a specialized work shop if this should not be the case.
42
Move the combination switch (5) upwards (choke position).
Grasp handle (hand pressure actuates the grip throttle lever lock (7)).
Push the throttle (8) in all the way and hold it.
Press the throttle lock (6) and release the throttle (8) (the throttle lock
will hold the throttle at half-throttle position).
43
Grasp the tubular handle firmly with one hand and press the cut-off
saw firmly against the ground:
Place the tip of your left foot in the rear handle.
Slowly pull out the starter rope until you notice resistance (the piston is
positioned before the top dead centre).
Now pull the starter rope with a fast and forceful movement until you
hear the first ignition.
Putting into operation
43