Connecting Wires To Terminals - Kenwood KDC-Z737 Instruction Manual

Connecting Wires to Terminals

If no connections are made, do not let the wire come out from the tab.
5 When using the optional power amplifier,
connect to its power control terminal.
7 Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
To car light control switch
23 To "EXT.AMP.CONT." terminal of the
amplifier having the external amp
control function.
Ignition key
switch
10
Car fuse box
(Main fuse)
11
+ –
Battery 12
Non-fading right output (Red)
(KDC-Z838 only)10
Non-fading left output (White)
(KDC-Z838 only)29
27 Rear right output (Red)
26 Rear left output (White)
2 KENWOOD disc changer control input
To connect the Disc changer,
consult your Disc changer
manual. 3
Power control wire (Blue/White)
Motor antenna control wire (Blue)
17
Dimmer control wire (Orange / White)
8
18
External amplifier control wire
(Pink / Black)
ACC 13
Ignition wire (Red)
Battery wire (Yellow)
Car fuse
box 14
Ground wire (Black) · (To car chassis)
Fuse
(10A) 24
Wiring harness
4
(Accessory1)25
15
20
20
21
22
— 32 — — 32 —
Front right output (Red)
Front left output (White)
AUX right input (Red)
AUX left input (White)
FM/AM antenna input
29
White/Black
To front left
speaker 30
White
31
32
Gray/Black
To front right
speaker 33
Gray
34
35
Green/Black
To rear left
speaker 36
Green
37
38
Purple/Black
To rear right
speaker 39
Purple
40
28
23
1