Table of Contents
Advertisement
General features
Audio Setup
Setting the Sound system, such as Cross over
Network.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item
Display
Front High Pass Filter*
2
"HPF-F"
Rear High Pass Filter*
2
"HPF-R"
Low Pass Filter*
1,2
"LPF"
1,2,3
Subwoofer Phase*
"SW Phase"
Volume offset
"VOL Offset"
Loudness
"Loudness"
Dual Zone System
"2Zone"
• Volume offset: Sets each source's volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
• *
1
You can control this item when <Subwoofer
Output> (page 12) is set to "SW ON".
2
• *
You can control this item when "2Zone" of <Audio
Setup> (page 12) is set to "OFF".
3
• *
You can control this item when Low Pass Filter is not
set to Through.
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by <Dual Zone
System Setting> (page 31).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [VOL] knob.
- Adjust the volume of Rear channel by <Audio
Control> (page 11).
- The Audio Control has no effect on sub source.
12
|
English
Range
Through/40/60/80/100/
120/150/180/220 Hz
Through/40/60/80/100/
120/150/180/220 Hz
50/60/80/100/120/
Through Hz
Normal (0°)/ Reverse (180°)
–8 — ±0
ON/OFF
ON/OFF
• You can use the Dual Zone System with the Auxiliary
input sources listed below.
- Internal auxiliary input
5
Exit Audio Setup mode
Press [VOL] knob for at least 1 second.
Subwoofer Output
Turning the Subwoofer output ON or OFF.
Hold down on [AM] of the Control knob for at
least 1 second.
Each time you press the button, Subwoofer
output switches ON and OFF.
When it is ON, "SW ON" is displayed.
• You can control this function when "2Zone" of <Audio
Setup> (page 12) is set to "OFF".
Display Setting
Changing the display mode.
1
Enter display Control mode
Press the Control knob for at least 1 second.
"Display Control" is displayed.
2
Select the Display mode
Press the Control knob.
Each time you press the knob, the display
alternates between the display modes shown in
the table below.
Display Mode
Display
"Display Type A"
5
"Display Type B"
5
"Display Type C"
4
1
2
3
Advertisement
Table of Contents
