General Operation; Audio Control; Audio Setup - Kenwood KDC-W237S Instruction Manual

General Operation

Audio Control

1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Audio item to adjust
Press the [VOL] knob.
Adjustment Item Display
Subwoofer level "SW L"
System Q "NATURAL"/
"ROCK"/"POPS"/
"EASY"/"TOP40"/
"JAZZ"/"USER"
Bass level "BAS L"
Middle level "MID L"
Treble level "TRE L"
Balance "BAL"
Fader "FAD"
Exit Audio Control mode (Volume control mode)
⁄
• "USER": This appears when Bass level, Middle level, and
Treble level are adjusted. When "USER" is selected,
these levels are recalled.
4
Adjust the Audio item
Turn the [VOL] knob.
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob.
6
|
KDC-W237S
Range
–15 — +15
Natural/Rock/Pops/Easy/Top
40/Jazz/User setting
–8 — +8
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15

Audio Setup

Setting the Sound system.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Adjustment Item Display
Low Pass Filter "LPF"
Volume offset "V-OFF"
⁄
• Volume offset: Sets each source's volume as a difference
from the basic volume.
4
Adjust the Audio setup item
Turn the [VOL] knob.
5
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Range
80/120/160/Through Hz
–8 — ±0 (AUX: -8 — +8)