Mooring Cover - Skier's Choice Supra Sunsport 20V Owner's Manual

Mooring Cover

Your Supra boat cover is made from the finest canvas and
webbing to ensure that your boat will be protected in the off
season. The cover has been designed to fit securely around
each boat.
Use the following procedure when covering the boat:
1. Be sure that the cover fits snugly at the bow then unfold
from front to back.
2. Be sure to install cover pole(s) and adjust to
proper height, using set screw on pole(s). This will keep
water from gathering in the center, which can damage
the cover.
3. Secure all fastening straps around the trailer frame.
4. Pull the draw cord equally from both sides and tie off
to the lifting eyes on the stern in accordance with the
illustration.
Folding Cover
When folding the cover for storage, be sure the cover is dry.
Take care not to scratch the canvas finish against rough sur-
faces. Store in a dry location.
Cover Repair
If the cover becomes damaged, immediately patch and reseal
the area. Use a tent seam sealer to reseal any new stitches.
Spray fabric guard on scraped or worn surfaces. Canvas
tears should be repaired professionally and stitches sealed
to prevent leakage.
DO NOT trailer the boat with the mooring cover installed.
The cockpit cover is not designed as a trailer cover and
may come unsnapped or rip. This type of damage IS NOT
covered by your boat warranty!
© 2008 Skier's Choice, Inc. © 2008 Skier's Choice, Inc.
Optional Tonneau Cover
The optional tonneau cover is designed to snap over the bow
of the boat. Its purpose is to minimize air flow into the cockpit
area when the boat is in use and as a storage cover when
used in combination with the optional cockpit cover.
DO NOT trailer the boat with the tonneau cover installed.
The tonneau cover is not designed as a trailer cover and
may come unsnapped or rip. This type of damage IS NOT
covered by your boat warranty!
Optional Cockpit Cover
The optional cockpit cover is a snap down storage cover de-
signed to help protect the interior of your boat. To install the
cover, start at the windshield and work towards the transom.
Be sure to install the cover poles to prevent water pocket-
ing.
DO NOT trailer the boat with the cockpit cover installed.
The cockpit cover is not designed as a trailer cover and
may come unsnapped or rip. This type of damage IS NOT
covered by your boat warranty!
 —