Skier's Choice Supra Sunsport 20V Owner's Manual page 38

Set Up Procedures (continued)
Resetting the Perfect Pass™ System
1. With the Info Center in Instrument System Mode, use
the SCROLL UP ARROW or SCROLL DOWN
ARROW buttons to display the Set Up screen.
2. Push the Enter button to display the Set Up
Menu screen.
3. Use the SCROLL UP ARROW or SCROLL DOWN
ARROW buttons to highlight the Service line in
the menu.
4. Push the Enter button.
5. Use the SCROLL UP ARROW or SCROLL DOWN
ARROW buttons to highlight the RESET PP line in
the menu.
6. Push the Enter button.
7. The Service screen will be displayed.
8. Push the Back button to exit the Service screen.
9. Push the Back button again will exit the Set Up Menu
screen.
Smart Plate
1. Info Center Main screen list enter button "auto" or "main"
with highlight. Use arrows to choose mode.
2. Once boat is above 16 mph, highlight toggles to %. Use
arrows to modify % dectection on auto mode.
3. Hit back to unhighlight.
— 
Trim Gauge Calibration
Note: The Trim Gauge is calibrated at the factory and need
not be recalibrated unless the indicated trim position no lon-
ger agrees with the physical position of the wake plate at its
extremes.
1. With the Info Center in Instrument System Mode,
use the SCROLL UP ARROW or SCROLL DOWN
ARROW buttons to display the Set Up screen.
2. Push the Enter button to display the Set Up
Menu screen.
3. Use the SCROLL UP ARROW or SCROLL DOWN
ARROW buttons to highlight the Trim Cal line in
the menu.
4. Push the Enter button.
5. The Trim Cal screen will be displayed.
6. Use the SCROLL UP ARROW or SCROLL DOWN
ARROW buttons to highlight the Down CAL line in
the menu.
7. Push the Enter button.
8. The DOWN CAL line will be highlighted and flashing.
Use the Manual Trim Switch to run the Trim Tab all
the way down and push the Enter button to store
the down value. The DOWN CAL line will stop
flashing and indicate DONE.
9. Use the SCROLL DOWN ARROW buttons to highlight
the UP CAL line in the menu.
10. Push the Enter button.
11. The UP CAL line will be highlighted and flashing.
12. Use the Manual Trim Switch to run the Trim Tab all
the way up and push the Enter button to store the up
value. The UP CAL line will stop flashing and
indicate DONE.
13. Push the Back button to exit the Trim Cal screen.
14. Push the Back button again to exit the Set Up Menu
screen.
© 2008 Skier's Choice, Inc. © 2008 Skier's Choice, Inc.