Trailer Alignment - Skier's Choice Supra Sunsport 20V Owner's Manual

Connecting the Trailer
When connecting the trailer to your tow vehicle use the fol-
lowing procedure:
1. Raise the tongue with the trailer jack, position the trailer
tongue directly over the 2" ball, and lower the jack
until the tongue goes all the way down over the ball.
2. Press down on the latch until it locks on the ball with
a "click."
NOTICE: If your hitch ball has an excessive flat spot on top,
the latch may not engage properly. If the latch does not catch,
check with your dealer or hitch installer before trailering.
3. Insert the locking pin into the tongue. Lock pin hole is
on the side of the tongue.
4. When all weight is off the trailer jack, pull the jack
lock pin and rotate the jack to the horizontal position
and re-lock the pin.
5. Attach the safety cables to the tow vehicle hitch.
Cross the cables and wrap them around each other
once or possibly twice allowing just enough slack to
permit tight turns of the vehicle and trailer.
6. Plug the trailer lights connector to the vehicle harness.
7. Clip the brake lockout cable to the vehicle hitch.
— 

Trailer Alignment

Correct Alignment
When pulling the boat onto the trailer, be sure that it is cen-
tered on the trailer.
Incorrect Alignment
The distance between the boat and the wheel runner board
should be equal on both sides.
© 2008 Skier's Choice, Inc. © 2008 Skier's Choice, Inc.