Power Requirements; Location Of Controls - Jensen JCR-275A User Manual

Am/fm dual alarm clock radio with wave sensor

Hide thumbs Also See for JCR-275A:

User manual (13 pages)

Table Of Contents

Table of Contents

Controls and Functions of Unit

AM/FM Band Button

2.  / Y-M-D / DST Button

Snooze / Sleep / Time Zone Button

Alarm Set Button

5. On / Off Button

6.  / Temp / °C/ °F Button

7. Alarm 1 Radio / Alarm Button

8. Alarm 2 Radio / Alarm Button

9. Time Set Button

10. LED Display

11. Reset Button

12. Auto Off / High / Low Dimmer

Switch

13. AC Power Cord

14. Temperature Sensor (For indoor

use)

15. FM Wire Antenna

16. Infrared Sensor

17. Aux In Jack

18. Volume Knob

19. Tuning Knob

20. Speaker

21. Rating Label

22. Battery Door

23. Night Light

24. Light On/Off Button

This unit operates on 120V~ 60Hz and requires 1 x CR2032 Lithium battery (not included) for

clock backup during power outage. Do not attempt to operate the radio on any other power source.

You could cause damage to the unit and void your warranty.

REPLACING BACKUP BATTERY

1. Remove the screw from the BATTERY COMPARTMENT COVER and remove the

compartment.

2. Install 1 brand new CR2032 Lithium 3V battery according to the polarity markings on the

BATTERY COMPARTMENT COVER.

3. Replace the BATTERY COMPARTMENT COVER and tighten the screw to secure the

compartment.

NOTE: The unit will operate without a battery installed, but your time and alarm settings will be lost

and will have to be reset in the event of a power interruption or failure.

IMPORTANT: Be sure that the battery is installed correctly.

Wrong polarity may damage the unit and void the warranty.

For best performance and longer operating time, we recommend the use of good

quality batteries.

CAUTIONS

Do not mix old and new batteries.

LOCATION OF CONTROLS