Application Modes; Weighing - OHAUS AV412 Instruction Manual

Adventurer Pro

3.5 Application Modes

The Adventurer Pro balance incorporates Weighing, Parts Counting, Percent Weighing, Check
Weighing, Animal Weighing, Display Hold and Totalize application modes. The default setting
has the weighing mode turned on and all other application modes turned off.
Note: Before using any application modes, they must be turned on in the Mode menu (See Section 3.3.4).

3.5.1 Weighing

Use this mode to determine the weight of items in the selected unit of measure. The Adventurer Pro
is shipped with grams enabled. Before using other units of measure, these units must be turned on
in the Unit menu ( See Section 3.7.5 ).
Weigh
Press and hold Mode until the display shows WEIGH, then
release the button.
Press Zero to zero the balance.
Place objects to be weighed on the pan to display the weight.
The example displays a 200 gram weight.
3.5.2 Parts Counting
Use the Parts Counting Mode to count samples of uniform weight.
Press and hold Mode until Count is displayed, then release the
button.
Establish an Average Piece Weight (APW).
Each time a new type of part is counted, the nominal weight of
one piece (Average Piece Weight) must be established using a
small quantity of pieces. This APW is stored until replaced by
another APW.
If an APW has already been established, Count is displayed
with Clear APW? blinking.
Press No to use the previously saved APW.
Otherwise, press Yes to establish a new APW.
The current weight (0.00) is shown on the primary display
and the default sample size (PLACE 10) is shown on the
secondary display.
To change the sample size, press and hold the No button to
increment the sample size through the range of 1 to 100.
Release the button when the desired sample size appears on
the secondary display.
(Clear APW? blinking)
EN-17