Before Setting Surface Controls - Frigidaire Gas Range Use & Care Manual

BEFORE SETTING SURFACE CONTROLS

Control locations of the gas surface burners
Your built-in range is equipped with gas surface burners
with different BTU ratings. The ability to heat food quicker
and in larger volumes increases as the burner size
increases.
The small simmer burner is best used for simmering
delicate sauces, etc. This burner is located at the right rear
burner position on the cooktop
burner can be used for most surface cooking needs. The
standard burners are located at the left front and left rear
positions on the cooktop
The power burners are best used for bringing large quanti-
ties of liquid rapidly up to temperature or when preparing
larger quantities of food. The POWER burner is located at
the right front position on the cooktop.
Regardless of size, always select cookware that is suitable
for the amount and type of food being prepared. Select a
burner and flame size appropriate to the pan. Never allow
flames to extend beyond the outer edge of the pan.
Figure 1: Burner locations
8
(Figure 1). The standard
(Figure 1).
Assembly of the surface burner caps and burner
grates
It is very important to make sure that all of the Surface
Burner Caps and Surface Burner Grates are installed
correctly and at the correct locations.
1. Remove all packing material from cooktop area.
2. Discard all packing material (if applicable).
3. Unpack Burner Grates and position on the cooktop.
IMPORTANT
Do not allow spills, food, cleaning agents or any other
material to enter the gas orifice holder opening.
Always keep the Burner Caps and Burner Heads in place
whenever the surface burners are in use.