Draytek Vigor2760 Series User Manual page 93

D e t a i l s P a g e f o r L
D e t a i l s P a g e f o r L
Available settings are explained as follows:
Item
Network Configuration
DHCP Server
Configuration
A N 2
A N 2
Description
Enable/Disable - Click Enable to enable such
configuration; click Disable to disable such configuration.
For NAT Usage - Click this radio button to invoke NAT
function (mandatory for IPv4).
IP Address - Type in private IP address for connecting to a
local private network (Default: 192.168.1.1).
Subnet Mask - Type in an address code that determines the
size of the network. (Default: 255.255.255.0/ 24)
DHCP stands for Dynamic Host Configuration Protocol.
The router by factory default acts a DHCP server for your
network so it automatically dispatch related IP settings to
any local user configured as a DHCP client. It is highly
recommended that you leave the router enabled as a DHCP
server if you do not have a DHCP server for your network.
Enable Server - Let the router assign IP address to every
host in the LAN.
Disable Server – Let you manually assign IP address to
every host in the LAN.
DHCP Server IP Address – It is available when Enable
Start IP Address - Enter a value of the IP address pool for
the DHCP server to start with when issuing IP addresses. If
the 1st IP address of your router is 192.168.1.1, the starting
IP address must be 192.168.1.2 or greater, but smaller than
192.168.1.254.
IP Pool Counts - Enter the maximum number of PCs that
you want the DHCP server to assign IP addresses to. The
default is 50 and the maximum is 253.
Gateway IP Address - Enter a value of the gateway IP
address for the DHCP server. The value is usually as same
83 Vigor2760 Series User's Guide