9
Figure 17
14. Torque screws to values listed in Section 14 -
Engine Specifications.
15. Install crankshaft pulley with timing mark at
12 o'clock position (Number 1 cylinder).
NOTE: Be sure alignment pin in crankshaft gear is
seated in hole in pulley.
16. Torque screw to values listed in Section 14 -
Engine Specifications.
17. Remove flywheel holder.
18. Install trigger assembly (A, Figure 18) and
wire.
Figure 18
Install Oil Pan
1. Install oil pan with new gasket.
2. Apply a small bead of sealant to crankcase
areas (A, Figure 19).
62
Figure 19
3. Torque screws to values listed in Section 14 -
Engine Specifications.
Install Alternator
1. Install alternator bracket and alternator
(Figure 20).
Figure 20
2. Torque screws to values listed in Section 14 -
Engine Specifications.
General Assembly
1. Lubricate tappets with engine oil and install in
cylinder block.
2. See Section 2 for installation of cylinder head
and related components.
3. See Section 3 for governor adjustment
procedure.