Disassembly Procedures; Replacing Oven; Removing Oven Bottom; Replacing Oven Ignitor Assembly - Maytag CWG3100AA Series Service Manual

Disassembly Procedures

Replacing Oven

1. Turn off gas and remove power from unit (at the
circuit breaker).
2. Open oven door and remove screws securing unit to
the wall.
NOTE: To avoid damage, do not move oven forward
until all cabinetry can be cleared.
3. Pull the oven forward out of the cabinet opening.
4. Disconnect or unplug the power cord leading from
unit to fuse box or junction box, depending on unit.
5. Turn off and remove gas supply from unit.
6. Replace the oven using the Installation Instructions.
NOTE: Perform gas leak test.

Removing Oven Bottom

1. Turn off gas and remove power from unit (at the
circuit breaker).
2. Remove oven door, see "Removing Oven Door"
procedure.
3. When oven is cool, remove oven racks.
4. Grasp the rear oven bottom latches and slide toward
the front of the oven.
5. Lift the rear edge of the oven bottom slightly and slide
back until the holes in the front edge clear the pins
located in the front frame of the oven.
6. Remove oven bottom and place in safe location.
7. Reverse procedures to reassemble.

Replacing Oven Ignitor Assembly

1. Remove oven bottom, see "Removing Oven Bottom"
procedure.
2. Remove screw securing oven burner flame spreader
(or baffle) to oven burner (model CWG3600AA* only).
3. Remove screws securing ignitor assembly mounting
bracket to oven back panel.
4. Remove screws securing ignitor to burner bracket.
5. Gently pull ignitor wires into oven cavity until the
disconnect block is within reach.
6. Disconnect oven ignitor assembly.
7. Reverse procedures to reassemble.

Replacing Oven Burner

1. Remove oven bottom, see "Removing Oven Bottom"
procedure.
2. Remove screw securing oven burner flame spreader
(or baffle) to oven burner (model CWG3600AA* only).
3. Remove screws securing oven burner to oven
chassis and support brackets.
4. Slide oven burner up and forward to remove.
5. Reverse procedures to reassemble.
14
To avoid risk of electrical shock, personal injury or
death; disconnect power and gas before servicing,
unless testing requires power and/or gas.

Replacing Pressure Regulator

1. Remove oven door, see "Removing Oven Door"
procedure.
2. Remove oven bottom, see "Removing Oven Bottom"
procedure.
3. Disconnect gas supply lines from regulator.
4. Remove screws securing regulator to support
bracket.
5. Reverse procedures to reassemble.
NOTE: When reconnecting supply line to regulator, use
pipe dope compound to seal the connection.
Once connected, perform gas leak test.

Replacing Oven Valve / Shut-off Valve

(Model CWG3600AA*)
1. Remove oven bottom, see "Removing Oven Bottom"
procedure.
2. Remove screw securing oven burner flame spreader
(or baffle) to oven burner.
3. Disconnect gas supply lines from valve.
4. Disconnect screws securing valve to support
brackets.
5. Slide valve out to remove.
6. If necessary, unscrew the oven valve from the shut-
off valve.
7. Reverse procedures to reassemble.
Flame Spreader/
Baffle w/nut
Pressure Regulator
and Support Bracket
Gas Tubing
Model CWG3600AA* Gas Controls
16026549
Oven Burner
Oven Burner
Fitting
Gas Tubing
Shut-off Valve
and Oven Valve
©2005 Maytag Services
Ignitor