Propane Gas Furnace - Winnebago Impulse Silver User Manual

SECTION 4 –
APPLIANCES AND SYSTEMS
Thermostat/Switch
•Move from OFF to desired
temperature for furnace operation
Room Temperature
3. Furnace fan should start to blow immediately
after setting the Thermostat.
4. After approximately 30 seconds, the Furnace
burner should light.
5. The Furnace should now cycle off and on
automatically as the Thermostat demands just
like a household furnace.
If heat does not come out of the heat ducts
after a minute or so, the burner is not lit.
Turn Thermostat OFF for 3-5 minutes, ensure
Propane Gas Tank valve is open and tank is not
empty, and repeat Steps 2 through 4.
If the Furnace will not light after three
attempts, follow "Shut Down" steps and contact
your dealer or a local RV service center for
repair.
NOTE: If the Furnace burner has any residuals
of metal protectant or lubricants used
during manufacture of the Furnace, it
may smoke slightly when the Furnace is
used for the first time and may set off
your smoke alarm.
We recommend that you provide
adequate ventilation when using the
Furnace for the first time to avoid a
4-8
Thermometer
nuisance smoke alarm.
We do not recommend removing the
smoke alarm battery.
To Shut Down
• Move Thermostat switch to OFF position.
• Close Propane Gas Tank valve if coach will be
stored for a period of time.
Further Information
Refer to the manufacturer's user guide
provided in your InfoCase for further
information, including operating precautions and
periodic maintenance. See the Coach
Maintenance Schedule for recommended
intervals.

PROPANE GAS FURNACE

To Start Up
1. Open the LP gas tank valve by turning fully
counter-clockwise.
2. Move THERMOSTAT switch from Off to
Heat and press the Temp Selector button (Up/
Down arrows) until the desired temperature is
shown in the display.
3. Furnace fan should start to blow immediately
after setting the thermostat.
4. After about 30 seconds, the furnace burner
should light.
Temp Selector
• Press up or
down to select
temperature