Table of Contents
Advertisement
There are two slideout motors equipped on the
end wall of each slideout room. Pull back wipe
seal to access motors.
NOTE: Use caution when removing components
on painted units.
Push-In Procedure
1. Using a razor blade, remove sealant from the
top of screw cover.
2. Using a flat-head screwdriver, push it up
underneath the screw cover and pull up to
release the cover. Remove the rest of the cover
by hand and set aside.
3. Remove the top (4) pan head screws and top
(4) flat head screws at the top of the aluminum
trim.
SLIDEOUT ROOMS
4. Gently pull aluminum trim away from
sidewall with hand to disengage screw from
motor.
5. Using a flat-head screwdriver, push bottom of
slideout motor UP to disengage
(approximately 1/2" from base).
Repeat on opposite slideout motor.
SECTION 10 –
10-5
Advertisement
Table of Contents
