Mounting The Miter Saw; Installation Of Miter Handle; Installation Of Table Extension; Installation Of Dust Bag - PowerTec MSS1000 Owner's Manual

CAUTION: Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
WARNING
Do not operate machine until completely assembled. Do
not operate machine until you have completely read and
understood this manual.

MOUNTING THE MITER SAW

Refer to Figure 2
• The miter saw must be installed in a well-lighted area
with correct power supply.
• The miter saw can be installed on either a workbench or
a tool stand by using bolts, lock washers, and hex nuts.
• The miter saw must be bolted to a firm and level
surface.
• There must be enough clearance for the moving
workpiece during operation and enough room for safety
operation of the machine.
• Figure 2 shows the base dimension and mounting
holds.
Figure 2
Ø3/8"

INSTALLATION OF MITER HANDLE

Refer to Figure 3
WARNING
Do not use the power cord or head assembly power
switch handle to carry the tool. Always lock the cutting
head in the down position when moving or storing the
saw.
• Insert the miter handle into the threaded hole located at
the front of the table.
Figure 3
16-3/4"
Miter handle

INSTALLATION OF TABLE EXTENSION

Refer to Figure 4
• Table extensions can be mounted both to the left and
right of the machine.
• Insert table extensions into the holes on the base of the
machine.
• Secure the table extensions by tightening the lock knob
located in the rear of the table.
Figure 4

INSTALLATION OF DUST BAG

Refer to Figure 5
• Slide dust bag onto the dust port.
• Regularly empty the dust bag.
Figure 5
INSTALLATION OF HOLD-DOWN CLAMP
ASSEMBLY
Refer to Figure 6
• Loosen the lock knob from the rear side of the saw
base.
• Place the hold-down clamp assembly in one of the
mounting holes.
• Tighten the lock knob located in the rear of the table.
3
Table Extension
Dust bag
Dust port