To Raise The Stand; Assemble Roller Bar; Mounting The Miter Saw - PowerTec MT4010 Owner's Manual

• Depressing the side of the wheel bracket with the
unlock symbol to unlock the wheel.
Figure 3
Unlocked

TO RAISE THE STAND

Refer to Figure 4
• Place a foot on the leg extension (wheel side of stand),
while holding the handle, reach under the stand and
pull downward on the quick release knob. Release
quick release knob when the stand reaches the desired
height. The stand will lock at 26-7/16" or 32-3/8".
Figure 4
Quick Release Knob

ASSEMBLE ROLLER BAR

Refer to Figure 5
• Place the roller arm into the roller bar support, slide up
and down to desired location.
• Place the locking knob into the small hole located on
the side of the roller bar support and tighten knob to
secure in place.
• Repeat on other side.
Figure 5
Roller Bar
Locking
Knob
Locked
Handle
32-3/8"
26-7/16"
Leg
Extension
Roller Bar
Roller Bar Support

MOUNTING THE MITER SAW

Refer to Figure 6-7
WARNING
Risk of accidental starting and serious personal injury.
Unplug the miter saw and lock the head down before
attaching it to the miter saw stand.
WARNING
Do not mount a table saw on this miter saw stand.
Aggressive feeding of sheet materials into a table saw
could cause the stand to tip over.
NOTE: This miter saws stand is to be used with miter
saws with four mounting holes in a rectangular pattern.
IMPORTANT: Lock wheels before mounting the miter saw
to the stand.
• Mount the miter saw to the quick-release mounting
brackets using the supplied hardware (M6 X 60
mounting bolt, washer, lock washers and nut) as shown.
NOTE: Some miter saws will not fit the quick connect
release bracket exactly. These saws need to be mounted to
a plywood base before attaching the quick release brackets.
Use the M6 X 27 mounting hardware set (supplied) to
mount the saw to a plywood base and then use the M6 x 60
mounting hardware set (supplied) to mount the saw/
plywood base to the quick release mounting brackets.
NOTE: Placing a 2 x 4 or spacer under one side of the
miter saw to raise the saw's mounting feet will make
assembly easier.
• After the saw is mounted to the quick release mounting
brackets make sure they are parallel to each other.
NOTE: The release levers may be oriented to the back
or front of the saw, make sure both of the release levers
are oriented in the same directions. The release levers
are shown oriented to the front in Figure 6. If the release
levers are mounted in the back all instructions will
be reversed.
Figure 6
Release
Lever
3
Nut
Lock Washer
Flat Washer
Bolt