Adjusting The Groove Depth - PowerTec MSS1000 Owner's Manual

Figure 9
Miter handle
90° BLADE ALIGNMENT
Refer to Figure 10
• Rotate table to 0 ° position and lock in place.
• Lower the blade and lock the cutting head.
• Place a combination square on the table and press it
against the blade to check the blade squareness to
table.
• If the blade is not 90 ° square with the miter table,
loosen the locknut on the adjusting screw.
• Adjust the screw to achieve a 90° angle.
• Tighten the locknut.
• Loosen the pointer screw and adjust the pointer to 0°
and tighten the screw.
Figure 10
Adjusting screw
45° BLADE ALIGNMENT
Refer to Figure 11
• Rotate table to 0 ° position and lock in place.
• Lower head assembly and lock in place.
• Loosen bevel lock handle and tilt the head assembly to
45 ° bevel. The pointer should be on the 45 ° mark.
•
Figure 11
Miter clamp knob

ADJUSTING THE GROOVE DEPTH

Refer to Figure 12
• Slide the groove stop into position.
• Loosen the locknut on the adjusting screw.
• Turn the screw to set the groove depth.
• Tighten the locknut.
• Slide the groove stop out of the way to cancel the
Figure 12
Pointer screw
Pointer
If the blade is not at 45 ° to the miter table, loosen
the locknut on the adjusting screw and adjust screw to
achieve a 45 ° angle and tighten the locknut.
Bevel scale
grooving feature.
Adjusting
screw
Locknut
Grooving stop
5
Adjusting screw