Table of Contents
Advertisement
CAUTION: Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
WARNING
Do not operate machine until completely assembled. Do
not operate machine until you have completely read and
understand this manual.
MOUNTING THE MITER SAW
Refer to Figure 2
• The miter saw must be installed in a well-lighted area
with correct power supply.
• The miter saw can be installed on either a workbench or
a tool stand by using bolts, lock washers, and hex nuts.
• The miter saw must be bolted to a firm and level
surface.
• There must be enough clearance for the moving
workpiece during operation and enough room for safety
operation of the machine.
• Figure 2 shows the base dimension and mounting
holds.
Figure 2
16-7/8"
Ø3/8"
INSTALLATION OF MITER HANDLE
Refer to Figure 3
WARNING
Do not use the power cord or head assembly power
switch handle to carry the tool. Always lock the cutting
head in the down position when moving or storing the
saw.
• Insert the miter handle into the threaded hole located at
the front of the table.
Figure 3
INSTALLATION OF REAR EXTENSION STAY
Refer to Figure 4
• Loosen the extension stay locking screw under the saw
base.
• Place the rear extension stay into the holes in the saw
base. Make sure the angle of the stay is in the down
position for maximum support.
• Insert the extension stay locking screw back to the hole
and tighten to hold the extension.
Figure 4
INSTALLATION OF TABLE EXTENSIONS
Refer to Figure 4
• Loosen the extension locking screws located in the rear
of the saw base.
• Place the table extension into the holes in the saw base.
• Insert the extension locking screws back into the hole
and tighten to hold the extension.
CUTTING HEAD
WARNING
Always lock the cutting head in the down position while
transporting or storing the miter saw.
Always use the specified carrying handle. Never carry
the saw by the switch handle, the cutting arm or the miter
handle.
RAISING THE CUTTING HEAD
Refer to Figure 5
• Push down slightly on the saw handle.
• Pull the hold down latch out of the long slot of locking
hole and turn 90° to insert into the short slot.
• This now will allow the saw switch handle to be raised to
the up position.
Miter handle
3
Rear extension stay
Table extension holes
Advertisement
Table of Contents
