Motor; Electrical Connections - PowerTec MSS1000 Owner's Manual

A temporary 3-prong to 2-prong grounding adapter (see
Figure 16) may be used to connect this plug to a matching
2-conductor receptacle. The temporary adapter should be
used only until a properly grounded outlet can be installed
by a qualified electrician.
Figure 15 - 2-Prong Receptacle
Grounded outlet Box
Adapter
In Canada, the use of temporary adapter is not permitted
by the Canadian Electric Code. Where permitted, the rigid
green tab or terminal on the side of the adapter must be
securely connected to a permanent electrical ground such
as a properly grounded water pipe, a properly grounded
outlet box or a properly grounded wire system.
• Many cover plate screws, water pipes and outlet boxes
are not properly grounded. To ensure proper ground,
grounding means must be tested by a qualified
electrician.
EXTENSION CORDS
Use proper extension cords. Make sure the extension
cord is in good condition. Use only 3-wire extension cords
have 3-prong grounding type plugs and 3-pole
receptacles which accept the tool plug. When using an
extension cord, make sure to use one heavy enough to
carry the current of the machine. An undersized cord will
cause a drop in the voltage, resulting in loss of power and
overheating. Use the table to determine the minimum wire
size (A.W.G.) extension cord.
Extension Cord Length
Wire Size................................................................. A.W.G.
Up to 25 ft....................................................................... 18
25 to 50 ft........................................................................ 16
NOTE: Using extension cords over 50 ft. long is not
recommended.

MOTOR

The Miter Saw is supplied with a 2.4 HP motor installed.
The 120 Volt AC universal motor has the following
specifications:
Horsepower (Maximum Developed)........................... 2 HP
Voltage......................................................................... 120
Amperes......................................................................... 15
Hertz............................................................................... 60
Phase........................................................................ Single
Cutterhead RPM........................................................ 4,800
Grounding
Means

ELECTRICAL CONNECTIONS

WARNING
• Turn the switch off and disconnect the machine from
power source before any repair or maintenance work.
• Some electrical wiring and connection work must be
performed by qualified electrician in accordance with
local regulations.
• There is a green grounding wire fastened to the frame of
the machine to provide Shock Protection. Do not
disconnect the Grounding Wire from the frame.
• The Motor is rated for used at 120 Volts.
• Connect this machine to 3-Conductor Power outlet with
appropriate rating only.
• Use only 3-pronged Extension Power Cord with
appropriate rating with this machine.
• When change the power cord, use only 3-pronged
Power Cord with appropriate rating.
• The Power switch is a Single Pole Rocker switch with
Locking Mechanism. Remove the Key when not in use
to prevent accidents.
7