Miter Cut; Compound Cut; Sliding Cut - PowerTec MSS1000 Owner's Manual

MITER CUT

• Slide the sliding mechanism to the rear as far as
possible.
• Tighten the slide lock knob to lock the sliding
mechanism in place.
• Lock the cutting head in 0 ° position.
• Loosen the miter clamp knob and rotate the miter table
to the desired angle position.
• Lock the miter clamp knob.
• Follow basic saw operation.

COMPOUND CUT

• Slide the sliding mechanism to the rear as far as
possible.
• Tighten the slide lock knob to lock the sliding
mechanism in place.
• Loosen the bevel lock handle and position the cutting
head at the desired bevel position. Lock the bevel lock
handle.
• Loosen the miter clamp knob and rotate the miter table
to the desired angle position.
• Lock the miter clamp knob.
• Follow basic saw operation.
OPERATION

SLIDING CUT

You can extend the cuts chop cut, miter cut, compound
cut to larger places by loosening the slide lock mecha-
nism.
• Release the slide lock mechanism to allow the sliding
mechanism to slide freely.
• Completely pull the cutting head towards the operator.
• Follow basic saw operation.
9