FCC Caution:
cables when connecting to computer or peripheral device. This device complies with Part 15 of the FCC Rules. Operation is
any interference received, including interference that may cause undesired operation.
This remote control may operate in humid environments, but not when placed on a wet surface.
SYNCHRONIZATION:
To create a unique link between your range hood and remote control please follow the below steps:
REMOTE CONTROL FEATURES:
The RF remote control is equipped with a magnet for easy storage. The remote may be placed on any magnetic surface such
as a refrigerator or the Zephyr remote holder. Maximum remote control communication distance from power pack is 15 feet.
Blower On/
Blower On/
1
2
Speed Selection
Power Off
3
4
Lights On/Dim/Off
5 Min Delay Off
+
A
Blower On/Speed Selection
1
By pressing
, the blower is switched On. Press
three blower speeds.
2
Blowers On/Hood Off
By pressing
, the blowers will power on at the last speed setting. Press
again and the entire hood will power off, including lights.
Delay Off
3
By pressing
, the blower and lights will enter Delay Off mode. A dot will
appear in the lower right corner of the power pack display
function is on. The blower will change to speed 1 and shut down after 5
minutes.
Lights On/Dim/Off
4
Switch lights On by pressing
REMOTE CONTROL MAINTENANCE:
Clean the remote control using non abrasive detergents
Follow instructions below for replacing battery.
in order to access the battery compartment.
-
Remove the battery and replace with Type A23 12V.
Negative end of battery should face the spring inside the remote.
Replace battery door and recycle old battery.
15
again to cycle through all
indicating the
once, again to dim and again to switch Off.
A
Need help?
Do you have a question about the Tornado II AK8200AS and is the answer not in the manual?