Storage; Push Stick - Craftsman 137.415030 Operator's Manual

5. Fold the stand slowly downward as
shown in Fig. F.
6. Move the saw to the desired
location for operation or store the
saw in a dry environment by using
the left side stand handles (10).
Fig. F
8

STORAGE

Rip fence and miter gauge (Fig. G)
Storage for the rip fence (1) and miter
gauge (2) are located on the left side of
the saw housing.
Fig. G
1
2
Extra saw blade and blade wrenches
(Fig. H)
1. Loosen and remove the knob (1) on
the right side of the saw housing.
2. Place blade wrenches (2), extra
blades (not included) onto the arbor.
Transporting
10
Folding
22 22
Fig. H
2
1
Push stick (Fig. I)
A storage holder for the push stick (1)
is located on the left side of the
saw housing.
1. Store the push stick (1) by hanging
it on the holders (2) through the
holes (3) of the push stick (1).
Fig. I
1
3
Installing the power cord storage
clamps (Fig. J)
1. Attach the power cord storage
clamp (1) into the hole set on the
rear side of the table saw base with
screw (2) and nut (3).
NOTE: The nut is placed inside
the base.
2. Repeat for the other clamp, to be
located on the bottom right on
saw base.
2