Laser-Track Laser Line Guide; To Adjust The Laser Line Guide; Using The Laser Line Guide; Blade Storage Compartment - Craftsman 135.17243 Owner's Manual

SM !6i9X00427 9-04 9/23/04 9:04 AM P_ 9
The 4 position control wheel allows you to
control the function of the lights. Below, lists
the function of each setting (Fig. 1).
Setting 1: Turns OFF all lights.
Setting 2: Turns ON only the laser light.
Setting 3: Turns ON both the laser light and
the worklight.
Setting 4: Turns ON only the worklight
The laser line guide is a class Ilia laser with a
maximum output power of 5.0m Watts and
conforms to 21 CFR 1040.10 and 1040.11.
LASER-TRAC
TM
LASER LINE GUIDE
The Laser-Trac line guide help you to follow
your cutting line with greater ease and
precision when making a cut.
TO ADJUST THE LASER LINE GUIDE
Use a flat head screwdriver to turn the
adjustment screw located on the side of the
laser module (Fig. 4). Turn on the laser line
guide by rotating the control wheel to setting
number 2. Rotate the adjustment screw until
the laser line is in the center of the blade.
There is no need to turn the tool "ON" while
adjusting the light beam.
The laser line guide has a limited amount of
travel. Do not continue to turn the adjustment
screw after the line stops moving or if it
becomes significantly harder to turn the screw.
Overturning the adjustment screw may cause
the adjustment system to break or cause the
adjustment screw to fall out of the tool.
USING THE LASER LINE GUIDE
Onty turn on the laser light on when the tool is
on the workpiece.
1. First mark the line of cut on your workpiece
(good side down.)
2. Insert plug into the power source.
3. Place the front edge of the saw foot on the
workpiece, turn the 4 position control wheel to
setting 2 for laser light only or setting 3 for
laser light and WORKLIGHT and align beam
with the line of cut.
4. Hold the tool firmly, squeeze the trigger and
allow the tool to reach desired speed.
5. Press down (to keep the saw foot flat
against the work surface) as you slowly push
the saw forward, keeping the beam in line with
the line of cut.
6. After completion of the cut, release the
trigger and turn off the laser light.
I/
•AVOID EXPOSURE- LASER
RADIATION IS EMITTEO FROM
THIS APERTURE. I
,,EVITE LA
EXPOSICII_N. DESDE I
ESTA ABERTU.RA
SEEMITE
RADIACIOH LASER. I
BLADE STORAGE COMPARTMENT
Your sabre saw is equipped with a blade
storage compartment in the dust port of your
saw (Fig. 5). To remove, pull compartment
out of dust port in direction of arrow,
Always make sure the bIade storage
compartment is securely in the dust port to
prevent blades from falling out.
i"[i_1
DUST
PORT
BLADE
COMPARTMENT
-9-