Connecting Wires To Terminals - Kenwood KRC-108S Instruction Manual

Connecting Wires to Terminals

If no connections are made, do not let the wire come out from the tab.
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.
Ignition key
switch
Car fuse box
(Main fuse)
+
Battery
2WARNING
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those wires
to the power source running through the fuse box.
P.CONT.OUT
ACC
Car fuse
box
Ground wire (Black) · (To car chassis)
–
Fuse (10A)
Power control/Motor antenna
control wire (Blue/White)
ANT.
CONT.
Ignition wire (Red)
Battery wire (Yellow)
2CAUTION
When only two speakers are being connected to the system,
connect the connectors either to both the front output
terminals or to both the rear output terminals (do not mix
front and rear). For example, if you connect the + connector
of the left speaker to a front output terminal, do not connect
the - connector to a rear output terminal.
— 13 —
FM/AM antenna input
Wiring harness
(Accessory1)
White/Black
To front left
speaker
FRONT • L
White
Gray/Black
To front right
speaker
FRONT • R
Gray
Green/Black
To rear left
speaker
REAR • L
Green
Purple/Black
To rear right
speaker
REAR • R
Purple