Volume; Attenuator; Loudness; Audio Control Setting - Kenwood KRC-108S Instruction Manual

General features

Volume

Increasing Volume:
Press the u button to turn up the volume.
Decreasing Volume:
Press the d button to turn down the volume.

Attenuator

This function allows you to turn down the volume quickly.
Turning Attenuator On/Off:
Press the ATT button to switch the attenuator on and off.
When the attenuator is on, the ATT indicator blinks.
When the attenuator is off, the volume returns to the original
level.
NOTE
Turning the volume up, or turning it all the way down deactivates
the attenuator function.

Loudness

This function amplifies low and high tones when the volume is
turned down.
The LOUD indicator lights up when the loudness function is on.
Turning Loudness On/Off:
Press the LOUD button for at least one second to switch the
loudness on and off.

Audio Control Setting

Adjust various parameters of sound quality.
1
Press the AUD button for at least one second to enter the
control mode.
2
Selecting mode
Press either the BAND button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the adjustment
modes.
NOTE
Source tone memory
Each source ( tape, FM and AM ) has its own memory in which to
store the bass and treble tone settings.
The settings made for a particular source are recalled
automatically whenever you use that source ( for example, FM
mode uses the tone settings made for FM, AM for AM, etc.).
3
Adjust each mode
Press the 4/¢ button.
Please refer to the following for the adjusting values.
4
Press the AUD button to end the control mode.
"BAS": Adjust the bass level.
Setting values: - 8 - + 8
"TRE": Adjust the treble level.
Setting values: - 8 - + 8
"BL": Adjust the balance level.
Setting values: Left 15 - Right 15
— 6 —